At the technical level, R-value is a measure of resistance to heat flow through a given thickness of material. In theory, the higher the R-value, the greater that resistance. That’s true to a point, but it’s just one of four key factors that determine the effectiveness of an insulation material. See the information below for a better understanding of these factors.
Most homeowners arriving at this page are searching for assistance with making an insulation purchase. A cellulose insulation producer can help those looking to make an informed decision. They can also recommend insulation contractors and installers that specialize in cellulose insulation. Find links to a producer near your region here on the website, or Contact CIMAC for more assistance.
One of the most important and misunderstood aspects of insulation is R Value. Unfortunately, R-Value has taken hold in the consumer’s mind as a universal method for comparing insulations - the higher the R-Value, the better the insulation, end of story. But all R-Values are not created equal, because they measure only one of the factors that determine how insulation will perform in the real world.
Insulation is, first and foremost, meant to stop the movement of heat. The problem with using R-Value as the sole yardstick of an insulation’s effectiveness is that heat moves in and out of your home (or about any other structure) in four ways: by conduction (which R-Value measures), and by convection, radiation and air infiltration (none of which R-Value measures). But let’s stick with the concept of R-Value for the moment.
The R-Values of insulation materials are measured in a lab. That would work great - if your home were inside a lab! But your home was built outdoors, and that means there are other factors like wind, humidity, and temperature changes in play. These factors create pressure differences between the interior and the exterior of the building due to things like hot air rising, wind, and mechanical systems forcing air through every tiny little opening and making its way to the interior or exterior, or to unconditioned areas of the building like attics, basements and crawl spaces.
Your home or commercial building may look solid, but there are thousands of tiny gaps, cracks and penetrations between building materials. For example, if you apply the air pressure of a 20 MPH wind on a 20 degree (F) day to a building, the typical R-19, batt insulated wall often performs no better than the wood studs (R-6) because of air infiltration, with heat being transported around (bypassing) the batts through convection. In very low density materials like loose blown fiberglass, heat will actually radiate right through the insulation, and this, along with convection, significantly reduces fiberglass' installed performance and your comfort.
A superior insulation system will have good R-Value (prevent heat loss via conduction), will be pneumatically or spray applied, fully filling the building cavity (prevent heat loss via convection), and will be densely packed (prevent heat loss via air infiltration and radiation). Cellulose meets all four of these critical performance criteria!
In addition, you want your insulation to do more than just insulate. Besides insulating, cellulose can help prevent the spread of flames in the event of a fire and blocks the transmission of sound. The insulation in your walls, ceilings, attic, etc., has a lot of jobs to do besides insulating - and cellulose is up to task!
Find more R-Value and other technical information from the Natural Resources Canada NRCAN website.